Computational references are not experiments: pre-registered validation of machine-learned sodium-cathode voltages

arXiv:2606.23725v1 Announce Type: cross Abstract: Machine-learning screens for battery materials are trained and judged almost entirely against computed reference voltages, and those references carry their own systematic errors. We report a case in which this matters quantitatively: our own screening stack (a graph-network voltage screen, a prior-art triage layer, and a local PBE+U bench) fails pre-registered validation against experiment-anchored literature values. Verdict thresholds, failure modes, and the primary metric were committed before analysis. On an operator-audited set of known Na-ion cathodes (n = 6 after one documented exclusion; verdict unchanged at n = 7), the raw held-out mean absolute error was 0.67 V, the pre-registered conservative metric, the upper 95% confidence bound of the cross-validated bias-corrected error, was 1.09 V, and the residual was strongly voltage-dependent (r = -0.94), so no additive calibration is valid. On the two compounds where prediction, database reference, and experiment could all be compared, the Materials Project PBE+U reference sat about 0.54 V below measurement: the reference, not the model, dominated the error. A prior-art screen found at least 70% of the targeted Na substitution space already published. We retire the screen, bound what "verified" means for our DFT ledger, and pre-register a calibration audit of it against four benchmark Li couples.