When to Skip Syndrome Extraction in Surface-GKP Codes
arXiv:2606.24469v1 Announce Type: new Abstract: Fault-tolerant quantum error correction requires repeated syndrome extraction to address errors induced by the syndrome-extraction circuit itself. However, repeated syndrome extraction incurs significant overhead in terms of gate count and ancilla consumption (e.g., Gottesman-Kitaev-Preskill (GKP) states). Moreover, noisy syndrome extraction can itself inject additional errors into the data qubits. To address these issues, we propose a concrete adaptive skipping scheme for the surface-GKP code, a representative GKP-concatenated architecture, that uses analog information naturally generated during inner GKP correction. At each round, the scheme selects one of four actions: measuring both Z-type and X-type surface-code stabilizers, measuring only one type, or skipping both types and reusing previous syndromes. The decision is based on a reliability comparison between reusing the previous syndrome value and performing a new noisy syndrome extraction. Using circuit-level simulations, we show that the adaptive skipping scheme can reduce the number of surface-code stabilizer measurements while maintaining logical error rates comparable to or lower than those of the full-measurement baseline. The improvement is most pronounced when gate and measurement noise are larger than idle noise, so that avoiding unnecessary syndrome extraction reduces the noise injected into the code. These results indicate that analog information from inner GKP correction can be used not only to improve decoding but also to reduce the measurement overhead of outer-code syndrome extraction.