Optimizing resource bounds in direct fidelity estimation
arXiv:2606.16336v1 Announce Type: new Abstract: Direct fidelity estimation provides a way to estimate the fidelity between an experimentally prepared state and a desired pure target state without performing full tomography. Two influential formulations were introduced in 2011 by Flammia and Liu and by da Silva, Landon-Cardinal, and Poulin. In these protocols, the total estimation error is controlled through two distinct probabilistic steps: first, the fidelity is approximated using randomly sampled Pauli observables; second, each sampled expectation value is estimated from finitely many measurement outcomes. In this work we show that additional structural information about the noise can substantially sharpen the corresponding resource bounds. In particular, for some canonical channels the effective number of sampled Pauli settings can be reduced, leading to lower measurement cost both in the general pure-state setting and in the case of a stabilizer state. These results illustrate a broader point: worst-case confidence bounds in direct fidelity estimation can be significantly conservative when experimentally relevant structure is ignored. As a technical ingredient, we also revisit the allocation of the total accuracy and confidence budgets between the two probabilistic steps. Reformulating the analysis in terms of separate error parameters yields a constrained optimization problem whose solution lowers the average number of measurements in the general pure-state setting. Numerical simulations based on quantum circuits implemented in Qiskit illustrate both the improvement obtained under structured-noise assumptions and the conservativeness of the original worst-case bounds.